A very important update to our supporters
We have been reluctant up to this point to give too much information about how we designed and built Airing because this is a proprietary invention with revolutionary implications. However, because we have not met our deadline of having a working prototype we feel we owe our loyal supporters more detail.
A high hurdle
In short, we hope we are close to having the micro-blowers functioning properly. As many of you already know, what makes the device work to treat sleep apnea are the tiny micro-blowers, many of them running in parallel, each one blowing a small amount of air, together blowing the right amount of air. While we achieved many of the engineering goals required to make Airing a reality, these micro-blowers are the tough piece of the puzzle for us and we have had some challenges getting them working.
Engineering is an iterative process and with each iteration you get closer to the goal. We have an engineering challenge we’re focused on that is proving to take much longer than we thought to get right. Specifically, we have two valves in each micro-blower that are designed to operate alternately: when one is closed, the other is open and vice versa. This happens thousands of times per second.
One of the valves appears to be working perfectly. But the other is about 90% of the way there. The problem, simply stated, is that it was “sticking”. In order to fix that, we had to thin it out, and lo and behold, now it doesn’t stick! That’s the good news. Now the issue is it’s too thin to be airtight so we need to find the precise thickness that will allow the valve to move freely while remaining airtight when in the closed position. We’ll get it! But each iteration takes a couple of weeks between designing the change, having it sent to the laser and sending it back to us to test.
Remember, all of this engineering is happening at microscopic scale so it’s a challenge to get it precisely right. But we believe we are close to making it work.
We have had our heads down, expecting every day to be “the” day we get to proclaim “we did it!” Perhaps that’s why we haven’t been as communicative with you as we should have been.
Since we outlined the challenge we are facing, I think it’s important to take stock of what we have accomplished:
Low cost integrated micro pressure sensor: prototyped and working
Nose buds that stay in place under high pressure: prototyped and working
Ergonomic outer plastic housing: prototyped and working
Micro-blower pump bodies: prototyped and working
Micro-blower valves operating thousands of times per second: prototyped and under test
We are grateful for your continued patience and support as we continue our work to bring these innovative technologies to fruition.